Products Eurolites - Latest Fitting Information
View All Products
European Motoring Kits
Eurolites Headlamp Adaptors
Alcohol Breathalyser
Magnetic UK Plates
UK Labels for GB Reg Plates
UK Stickers - Twin Pack
Motorcycle UK Plate
Warning Triangle
Spare Bulb Kit
Fire Extinguisher
First Aid Kit
Hi-Vis Reflective Vest
Blue Zone Parking Permit
DriveRight Lane Safety Device
SpeedRight Speedo Converter
Caravan Speed Stickers
Motorcycle Helmet Stickers
Dual USB In-Car Charger
Travel Plug Adaptors
Ticket Clip - Ticket Holder
Bug Shifter Screen Sponge
Magnetic St George's Flag
Emergency Thermal Poncho


Left Hand Drive Vehicles

Thank you for purchasing our Travel Spot Headlamp Adaptors (also packaged as Halfords / AA / RAC, etc.) Please fit as follows:

Open the packaging and remove the card + the folded ‘fitting information’ leaflet. Now follow the flow chart below:

Fitting Eurolites flowchart

Universal Fitting Information

Firstly, you will need to gain access to a ‘Headlamp Alignment’ machine. These can be found at most Vehicle Dealers or Servicing garages and at ALL vehicle testing garages. Position your vehicle in front of the alignment machine with the Headlamps switched onto ‘Dipped Beam’ (i.e. No blue ‘Full Beam’ light illuminated on you dashboard).

The headlamps will throw a light pattern in the machine similar to the one shown in the diagram below (Areas ‘A’ + ‘B’).

Fitting Eurolites Diagram

Passenger's Side:
Driver's Side:

It is the ‘raised’ area marked ‘A’ on the diagram which is used to illuminate road signs etc, when driving on the right in your country. However, this area will shine into oncoming driver’s eyes when driving on the left in the UK, and therefore needs to be adapted to prevent dazzle. This can be achieved as follows:

Without removing the backing paper, take hold of the ‘tail’ end of an adaptor and offer the ‘round’ end up to the Headlamp in various positions (see folded leaflet for typical positions – Diagrams 1 - 8 are the most commonly used). The aim is to achieve a reasonable dimming of the ‘dazzle causing Area’ –A, without compromising the overall brightness of the headlamp’s beam ‘hotspot’ (Area ‘B’). By a process of experimentation it will be possible to find the optimum position for the Adaptor.

NOTE: Ideally, the engine should be left running during this process to ensure maximum beam clarity.

Once the fitting position has been identified, the adaptors should be applied using the ‘fitting Instructions’ section of your leaflet.

NOTE: Generally, the Adaptor will fit in the same position (NOT the opposite position) on each of the two Headlamps. For example, if the Adaptor fits in the bottom right corner of the Driver’s side Headlamp, it will also fit in the bottom right corner of the Passenger’s side headlamp.

We trust the above information will allow you to successfully apply your Eurolites, but please email us at help@travelspot.co.uk if you have any further questions.

Left Hand Drive Vehicles



Fitting Eurolites Headlamp Beam Adaptors


Latest Fitting Information

Latest vehicle updates... Download